Tutorial on how to extract whitelist data

Please note: To use the IP whitelist extraction function, the user's IP must be added to the whitelist.

1. Add IP whitelist

Click 【Whitelist】 to add IP whitelist

1. Whitelist addition completed

1. Extract using API link

Select 【Endpoint generator】 on the endpoint generator page

1. Configure extraction related parameters

(1)Extraction Type:

【Link Extraction】 Extract IP by opening the generated API link.

【Direct Generation】 Direct or area name: port information

(2) Region: The country to be extracted

(3) Number: Extract quantity

(4)Session Type:

【Rotating session】 Select a rotating session to obtain a new IP on each request

【Sticky session】 Keep the same IP address for up to 30 minutes through a sticky session

You can also modify the relevant parameters directly in AP|Link to configure

The following are instructions for modifying parameter configuration

Modify the number of extracted IPs: If you need to adjust the number of extracted IPs, please modify the num parameter. For example, change the num parameter to num=15 http://extract.piaproxy.com/get_data_center_ip?neek=1119454482&num=15&regions=all&ip_si=2

Modify the extraction country: If you need to adjust the extracted countries, please modify the regions parameter. For example, to extract the US IP, change the regions parameter to regions=us http://extract.piaproxy.com/get_data_center_ip?neek=1119454482&num=15&regions=us&ip_si=2

Click here to view the list of supported countries and codes

To modify the session type: If you need to change the session type, please modify the ip_si parameter. 1 represents a sticky session, and 2 represents a rotating session. For example, if you need to use a rotating session, change the ip_si parameter to ip_si=2 http://extract.piaproxy.com/get_data_center_ip?neek=1119454482&num=15&regions=us&ip_si=2